set-ip-address
Node module for setting up network interface(s) ip address, dns, and default routes of physical network interfaces, VLAN, and bridged interfaces.
Supported linux network configurations:
- dhcpcd (/etc/dhcpcd.conf)
- ifdownup (/etc/network/interfaces)
- netplan (/etc/netplan/)
Install
yarn add set-ip-address
OR
npm i --save set-ip-address
Basic Usage
var set_ip_address = require('set-ip-address')var eth0 = {
interface: 'eth0',
ip_address: '10.0.0.1',
prefix: 20,
gateway: '10.0.0.1',
nameservers: ['8.8.8.8'], // nameservers can also be a string separated by space/comma, ex: `"1.1.1.1, 8.8.8.8 8.8.4.4"`
optional: true // (netplan) - dont wait for interfaces to avoid boot delay
}
var eth1 {
interface: 'eth1',
dhcp: true
}
set_ip_address.configure([eth0, eth1]).then(() => console.log('done writing config files')Create and Configure VLAN Interface
You can create vlan interfaces by passing vlanid option. Make sure to load 8021q module to the kernel:
sudo modprobe 8021q
var eth0 = {
interface: 'eth0',
ip_address: '10.0.0.1',
prefix: 20,
gateway: '10.0.0.1',
nameservers: ['8.8.8.8']
}
var vlan1 {
interface: 'eth0',
vlanid: 10,
ip_address: '20.0.0.1',
prefix: 20,
gateway: '20.0.0.1',
nameservers: ['8.8.8.8']
}
set_ip_address.configure([eth0, vlan1]).then(() => console.log('done writing config files')Create and Configure Bridged Interfaces
var eth0 = {
interface: 'eth0',
manual: true
}
var vlan1 {
interface: 'eth0',
vlanid: 10,
manual: true
}
var br0 = {
interface: 'br0',
ip_address: '10.0.0.1',
prefix: 20,
gateway: '10.0.0.1',
nameservers: ['8.8.8.8'],
bridge_ports: ['eth0', 'eth0.10'],
bridge_opts: {
stp: true
}
}
set_ip_address
.configure([eth0, vlan1, br0])
.then(() => console.log('done writing config files')Create and Configure PPPoE Interface
var ppp = {
provider: 'dsl-provider',
physical_interface: 'eth0'
}
set_ip_address
.configure([ppp])
.then(() => console.log('done writing config files')Restart Networking Service
set_ip_address.restartService()
.then(() => console.log('network service restarted'))